FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   - 3.4. Ignition and engine management systems
      3.4.1. A technical characteristics
      - 3.4.2. Ignition and engine management systems
         3.4.2.1. System of ignition ESC II
         3.4.2.2. System of ignition ЕЕС IV
         3.4.2.3. The ignition distributor
         3.4.2.4. Check of a corner of installation of an advancing of ignition
         3.4.2.5. The ignition block (models with system of injection of fuel)
         3.4.2.6. The ignition coil
         3.4.2.7. A fuel trap on engines with the carburettor
         3.4.2.8. The engine management block
         3.4.2.9. The step-by-step engine of the carburettor
         3.4.2.10. The device of heating of an inlet collector of engines with the carburettor
         3.4.2.11. The relay of a control system of the engine
         3.4.2.12. Installation of a corner of an advancing of ignition and idling turns
         3.4.2.13. The gauge of turns and position of a cranked shaft
         3.4.2.14. The gauge of temperature of air
         3.4.2.15. The gauge of temperature of fuel
         3.4.2.16. The gauge of speed of the car
         3.4.2.17. The gauge of absolute pressure in a collector (MAP)
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



3.4.2.5. The ignition block (models with system of injection of fuel) ENGINES OHC AND V6

PERFORMANCE ORDER
1. To remove a negative wire from the accumulator.
2. To disconnect многовыводной a socket from the ignition distributor.
3. On models V6 to put combination labels between the case of the distributor of ignition and the engine. To weaken a bolt of fastening of the distributor of ignition and to turn the distributor of ignition for access to screws of fastening of the block of ignition.
4. To unscrew two screws of fastening of the block of ignition (are specified by arrows), to shift the block downwards and to remove it from the ignition distributor.
5. Before installation into place to put on a back part of the block теплопроводную paste Ford 815F-12103-AA.
6. To establish the ignition block into place and to fix two screws.
7. On models V6 to return the ignition distributor in initial position, to check up installation of a corner of an advancing of ignition, and to tighten a fastening bolt.
8. To connect многовыводной a socket of the distributor of ignition.

ENGINE DOHC

The block of ignition of engine DOHC

The ignition block is located in the left forward corner of a motor compartment, about the case of the air filter.

PERFORMANCE ORDER
1. To remove a negative wire from the accumulator.
2. For access improvement to remove the case of the air filter.
3. To remove a socket from the ignition block.
4. To unscrew two screws and to remove the block from a motor compartment.