FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   - 3.4. Ignition and engine management systems
      3.4.1. A technical characteristics
      - 3.4.2. Ignition and engine management systems
         3.4.2.1. System of ignition ESC II
         3.4.2.2. System of ignition ЕЕС IV
         3.4.2.3. The ignition distributor
         3.4.2.4. Check of a corner of installation of an advancing of ignition
         3.4.2.5. The ignition block (models with system of injection of fuel)
         3.4.2.6. The ignition coil
         3.4.2.7. A fuel trap on engines with the carburettor
         3.4.2.8. The engine management block
         3.4.2.9. The step-by-step engine of the carburettor
         3.4.2.10. The device of heating of an inlet collector of engines with the carburettor
         3.4.2.11. The relay of a control system of the engine
         3.4.2.12. Installation of a corner of an advancing of ignition and idling turns
         3.4.2.13. The gauge of turns and position of a cranked shaft
         3.4.2.14. The gauge of temperature of air
         3.4.2.15. The gauge of temperature of fuel
         3.4.2.16. The gauge of speed of the car
         3.4.2.17. The gauge of absolute pressure in a collector (MAP)
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



3.4.2.12. Installation of a corner of an advancing of ignition and idling turns
THE GENERAL DATA

Socket of a step of regulation OCTANESого numbers

The socket is specified by an arrow.

Arrangement of elements of regulation of delay of ignition

1 – a grounding place (the screw of fastening of the coil of ignition),

2 – a socket,

3 – not earthed wires

On all models have possibility for reduction of a corner of an advancing of ignition to six degrees without change of position of the distributor of ignition. Adjustment is intended for use of fuel of not corresponding grade.

Adjustment is made by grounding of one or two wires (sometimes named "OCTANESое regulation") which come to an end in многовыводном a socket near to the ignition coil.

As a result of this adjustment dynamic characteristics and efficiency of the engine will decrease. After pouring of fuel of a demanded grade, it is necessary to return adjustment in initial position.

Grounding of a yellow adjusting wire increases idling turns by 75 rpm (OHC) or 50 rpm (V6).

Variants of delay of a corner of ignition

Colour of a wire
The carburettor
Injection system
V6
Dark blue
2
2
6
The red
4
4
3
Dark blue with the red
6
6
The forbidden










чебуреки с мясом рецепт рецепт с фото