FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
- 14. An electric equipment
   14.1. A technical characteristics
   14.2. Safety locks and the relay
   14.3. Electronic blocks of management
   14.4. System of the central blocking
   14.5. System of indexes of turns
   14.6. The fuel computer
   14.7. Additional control system
   - 14.8. The generator
      14.8.1. Removal and generator installation
      14.8.2. Dismantling and generator assemblage
      14.8.3. Replacement of brushes of the generator and a pressure regulator
      14.8.4. The basic malfunctions of the generator
      14.8.5. Tension adjustment клинового a belt
   + 14.9. A starter
   + 14.10. A windscreen screen wiper, knot of indexes and a headlight
   14.11. Removal and installation of a combination of devices
   14.12. External and internal illumination
   + 14.13. An other electric equipment
   + 14.14. Electroschemes



14.8.2. Dismantling and generator assemblage
THE GENERAL DATA

Generator Bosch

1 pulley of the fan,
2 – a forward cover,
3 – a rotor,
4 – the bearing,
5 – статор,
6 – the rectifier,
7 – a back cover,
8 – щеткодержатель,
9 – an electronic regulator
Pressure

Generator Lucas

1 pulley of the fan,
2 – a forward cover,
3 – a rotor,
4 – the bearing,
5 – статор,
6 – the rectifier,
7 – a back cover,
8 – щеткодержатель,
9 – an electronic regulator
Pressure

Generator Motorola

1 pulley of the fan,
2 – a forward cover,
3 – a rotor,
4 – the bearing,
5 – статор,
6 – the rectifier,
7 – a back cover,
8 – щеткодержатель,
9 – an electronic regulator
Pressure

In the course of generator repair it is necessary to adhere to following instructions:

  – The diodes placed in the generator, are sensitive to a heat; in case of need their replacements in soldering process it is necessary to hold their conclusions with metal tweezers which take away heat from a soldering iron sting, and also to limit to a necessary minimum soldering time;

  – It is necessary to avoid use of not earthed electric soldering irons as in case of damage of their isolation they will cause breakdown выпрямительных generator diodes;

  – In the course of control tests of the generator of pressure of a food should not exceed 14В;

  – In the course of check выпрямительных diodes it is possible to use a direct current the pressure, not exceeding 24 In;

  – For cleaning of details it is necessary to use exclusively gasoline; at once after cleaning of details (especially windings) it is necessary to drain them a stream of compressed air.