FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   + 5.4. System of giving of air
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   + 5.7. Carburettor WEBER 2V TLD
   - 5.8. System of injection of fuel
      5.8.1. Adjustment of turns of idling and quality of a mix
      5.8.2. Removal and installation of the gauge of position throttle заслонки
      5.8.3. Removal and installation of the valve of management by idling turns
      5.8.4. Removal and installation of measuring instruments of a stream of air
      5.8.5. Removal and installation of fuel atomizers
      5.8.6. Removal and installation of the temperature gauge of a fuel highway
      5.8.7. Removal and installation of a regulator of pressure of fuel
      5.8.8. Removal and installation of the case throttle заслонки on engine DOHC
      5.8.9. Removal and installation of the oxygen gauge (HEGO)
      5.8.10. Removal and installation of a coal adsorber
      5.8.11. Removal and installation of the electromagnetic valve of a coal adsorber
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



5.8.2. Removal and installation of the gauge of position throttle заслонки
PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove a socket (2) gauges of position throttle заслонки (1). On engines ONS it is located below the valve of turns of idling, from an underside of the inlet pipeline. On engines DOHC and V6 it is located under a casing throttle заслонки.
3. To unscrew the gauge of position throttle заслонки and to remove the gauge from an axis throttle заслонки (fastening bolts are specified by arrows).
4. It is not recommended to rotate the central part of the gauge against its normal rotation, it can put the gauge out of action.
5. At installation to combine a facet on an axis throttle заслонки with a facet on the gauge centre.
6. To establish the gauge and to screw two bolts.
7. To connect a socket to the gauge.