FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   - 5.4. System of giving of air
      5.4.1. Removal and installation of the air filter
      5.4.2. A temperature regulator
      5.4.3. The fuel pump
      5.4.4. Replacement of the fuel filter by engines with system of injection of fuel
      5.4.5. Removal and installation of a fuel tank
      5.4.6. Removal and installation of the gauge of measurement of level of fuel
      5.4.7. Removal and installation of the inertial switch of giving of fuel
      5.4.8. Removal and installation of a pedal of an accelerator
      5.4.9. Removal and installation of a cable of an accelerator
      5.4.10. A steam separator
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   + 5.7. Carburettor WEBER 2V TLD
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



5.4.9. Removal and installation of a cable of an accelerator
PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To disconnect a cable of an accelerator from a pedal.
3. To take a cover of a cable from a partition and to extend a cable in a motor compartment.
4. On engines with the carburettor to remove the air filter.
5. On engines V6 to uncover the throttle side scenes, fastening three screws (are specified by arrows).
6. To disconnect a cable from the lever of a drive of a throttle (it is specified by an arrow) on the carburettor or the module of system of injection.
7. To remove a cover of a cable from скобы.
8. Installation is made in sequence of return to removal. To adjust a cable, rotating the carving plug of an exit of a cover that at the released pedal insignificant sagging of a cable was observed.