FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   - 5.4. System of giving of air
      5.4.1. Removal and installation of the air filter
      5.4.2. A temperature regulator
      5.4.3. The fuel pump
      5.4.4. Replacement of the fuel filter by engines with system of injection of fuel
      5.4.5. Removal and installation of a fuel tank
      5.4.6. Removal and installation of the gauge of measurement of level of fuel
      5.4.7. Removal and installation of the inertial switch of giving of fuel
      5.4.8. Removal and installation of a pedal of an accelerator
      5.4.9. Removal and installation of a cable of an accelerator
      5.4.10. A steam separator
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   + 5.7. Carburettor WEBER 2V TLD
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



5.4.10. A steam separator
THE GENERAL DATA

Fuel steam separator without a pressure regulator

1 – a returnable fuel hose,

2 – a submitting fuel hose,

3 – fuel giving in the carburettor

Fuel steam separator with a pressure regulator

1 – a submitting fuel hose,

2 – a returnable fuel hose,

3 – fuel giving in the carburettor

Carburettor models are equipped by the steam separator, established on the left forward internal wing. On models 1,8 дм3 the separator includes a pressure regulator.

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To mark three hoses connected with a steam separator. To disconnect hoses from a steam separator.
3. To unscrew two screws of fastening and to remove a steam separator.
The prevention

The steam separator is always filled by fuel.


4. Installation is made in sequence, return to removal.