FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      + 3.2.2. The repair which is not demanding removal of the engine
      - 3.2.3. Removal and installation of the engine without a transmission
         3.2.3.1. Engine removal
         3.2.3.2. Additional operations on engine removal on cars with АКП
         3.2.3.3. Additional operations on removal of the engine from a transmission
         3.2.3.4. Engine installation
         3.2.3.5. Engine dismantling
         3.2.3.6. Cylinders
         3.2.3.7. Check and restoration of pistons and piston rings
         3.2.3.8. Piston fingers and rods
         3.2.3.9. A cranked shaft
         3.2.3.10. Radical and шатунные bearings
         3.2.3.11. A flywheel
         3.2.3.12. Engine assemblage
         3.2.3.13. Start of the engine after major repairs
      3.2.4. Ventilation system картера
      + 3.2.5. Greasing system
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



3.2.3.4. Engine installation
THE GENERAL DATA

Engine installation is made in sequence, to removal, thus it is necessary to pay attention of return to some features:

 – Greasing by oil шлицов a shaft of coupling of a transmission before connection of these knots;
 – At coupling installation on a flywheel it is necessary to centre a disk of coupling aligning оправкой;
 – If at joining of a transmission to the engine, the primary shaft of a transmission does not enter into a coupling disk it is necessary to turn a cranked shaft of the engine a little;
 – To establish a new lining of a forward exhaust pipe;
 – To fill system of cooling with a corresponding liquid and to remove air from cooling system;
 – To check up and in case of need to adjust a corner of an advancing of ignition, and also number of turns of the engine idling and concentration WITH in exhaust gases.