FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   + 5.4. System of giving of air
   - 5.5. Carburettor PIERBURG
      5.5.1. Adjustment of turns of idling and quality of a mix
      5.5.2. Adjustment демпфера throttle заслонки the first chamber
      5.5.3. Adjustment of a starting backlash air заслонки
      5.5.4. Removal and carburettor installation
      5.5.5. Carburettor dismantling
      5.5.6. Carburettor assemblage
      5.5.7. Adjustment of fast idling
      5.5.8. Carburettor Pierburg changes 2V since September 1986 г
   + 5.6. Carburettor WEBER 2V
   + 5.7. Carburettor WEBER 2V TLD
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



5.5.4. Removal and carburettor installation
PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove the air filter.
3. To disconnect a wire automatic air заслонки from a thermoswitch.
4. To disconnect a throttle arm (it is specified by an arrow) from the lever.
5. To remove a hose of giving of fuel in the carburettor. At presence on hoses of coupling collars to bite off them and instead of them to establish the collars clamped by the screw.
6. At the hot engine to remove pressure in system of cooling of the engine for what, being careful, to unscrew a stopper on a broad tank.
7. To remove hoses of giving of a cooling liquid from the case automatic air заслонки, to lift them upwards and to muffle stoppers (it is shown by an arrow).
8. To unscrew three screws of fastening of the carburettor to an inlet collector.
9. To remove the carburettor and to close an aperture in an inlet collector pure rags.
10. Carburettor installation is made in sequence, return to removal. After installation to adjust turns of idling and the maintenance WITH.