FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   - 3.3. Engine V6
      3.3.1. A technical characteristics
      3.3.2. The repair which is not demanding removal of the engine
      3.3.3. Engine removal
      + 3.3.4. Dismantling and check of details of the engine
      + 3.3.5. Changes in a design of engines V6 2,4 and 2,9 дм3
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


3.3.3. Engine removal
THE GENERAL DATA

Removal of the engine without a transmission is made upwards from a motor compartment by means of the load-lifting mechanism. It is possible to make also engine removal together with a transmission, however, it much more difficultly as for this purpose it is required to establish the car on the lift and by means of the additional lift to lower the engine together with a transmission downwards, preliminary having disconnected and having removed the units interfering lowering of the power unit.

PERFORMANCE ORDER
1. To remove a negative wire from the accumulator.
2. To remove protection картера and a mudguard.
3. To remove a radiator lattice.
4. To disconnect a cable of opening of a cowl from the mechanism of closing of a cowl and to take from clamps.
5. To remove a cowl, preliminary having noted position of loops, for simplification of repeated installation and having disconnected a tube of a washer of a windscreen.
6. To unscrew three screws and to uncover the throttle valve.
7. To uncover the air filter, a flowmeter of air and an inlet air route.
8. To uncover маслозаливной mouths.
9. To unscrew bolts and to remove the top part of a casing of the fan.
10. To merge cooling liquid from cooling system for what under a drain stopper of a radiator to substitute the corresponding container and to open the drain stopper located in the bottom part of a radiator. For acceleration plum of a cooling liquid to open a stopper of a broad tank. For plum of a cooling liquid from the block of cylinders to unscrew the drainage bolt located in the block of cylinders.
11. To disconnect hoses of system of cooling from a heater radiator.
12. To remove the fan with муфтой viscous coupling.
13. To disconnect a vacuum tube of the amplifier of brakes from an inlet collector.
14. To disconnect electric wires and to remove sockets from following units and gauges:
      – The generator;
      – A starter;
      – The temperature gauge;
      – The gauge of temperature of a control system of the engine;
      – The gauge of pressure of oil;
      – The electromagnetic valve on the fuel pump of a high pressure;
      – The gauge of position throttle заслонки;
      – Electromagnetic муфты the fan;
      – The valve of turns of idling;
      – The distributor;
      – Injectors;
      – A radiator temperature-sensitive element.
15. To disconnect from the engine a weight wire.
16. To disconnect an accelerator cable, a cable of fall of transfer of an automatic transmission or the electromagnetic switch of fall of transfer.
17. To depressurize fuel system and to disconnect hoses of giving and fuel return.
18. To remove auxiliary приводные belts of the hydraulic booster of a steering and the conditioner. To unscrew the pump and the compressor of the conditioner and by means of a soft wire to suspend to a body without disconnecting from them hoses.
19. To uncover and a rotor of the distributor of ignition together with wires.
20. To remove a starter.
21. To merge engine oil and to remove the filter.
22. To remove a coupling cable.
23. To unscrew a forward reception pipe from a final collector.
24. On cars with an automatic transmission to unscrew the converter of a twisting moment from drive a disk.
25. To establish таль for lifting of the engine and to raise the engine, and then to unscrew holders of the engine.
26. Being careful, the load-lifting mechanism to raise the engine and to unscrew an arm of fastening of the engine to support.
27. To unscrew a back guard of the engine.
28. To unscrew fastening bolts картера couplings.
29. To prop up a transmission by means of the corresponding lift and a wide board and a few to raise a transmission.
30. Being careful, the load-lifting mechanism to raise the engine and to separate from it a transmission.
31. To take the engine from a motor compartment.