1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
- 7. Transmissions
   + 7.1. A mechanical five-speed transmission of type
   + 7.2. A mechanical transmission of type МТ 75
   - 7.3. Automatic transmission А4LD
      7.3.1. A technical characteristics
      - 7.3.2. Service and repair The work description Check of level of oil in a transmission Check and washing of a hydrokinetic transmission Check of pressure of oil in a transmission operating time Test of an overload of the engine by hydrokinetic transfer Adjustment of a tape of a brake of forward planetary transfer Removal and installation of a vacuum regulator The hydraulic booster of back planetary transfer A centrifugal regulator of pressure of oil Replacement of a back sealing ring Removal and installation of the mechanism of a choice of transfers Removal and installation of draught of a choice of transfers
         + Adjustment of a cable of mechanism Kick-down Removal and transmission installation Malfunctions of an automatic transmission
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment A centrifugal regulator of pressure of oil

Elements of a centrifugal regulator of pressure of oil

1 – грузик,

2 – a spring,

3 – the valve,

4 – the regulator case

Removal and installation

1. To establish the car over the viewing channel or on the lift and to disconnect a wire of weight from the accumulator.
2. To unscrew two bolts and to remove an intermediate support карданного a shaft.
3. To disconnect a cross-beam of a suspension bracket from a transmission and being careful to lower a transmission.
4. To unscrew two bolts and to remove a speedometer drive.
5. To unscrew six bolts and to remove картер the transmission extension piece.
6. To unscrew two bolts of fastening (are specified by arrows) and to remove a centrifugal regulator of pressure of oil from a nave.
7. Installation is made in sequence, return to removal. At regulator installation to turn a shaft so that apertures for bolts of fastening of a regulator were below, thus the regulator spring should be between the valve and грузиком.