FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
- 7. Transmissions
   + 7.1. A mechanical five-speed transmission of type
   - 7.2. A mechanical transmission of type МТ 75
      7.2.1. A technical characteristics
      + 7.2.2. Service and repair
   + 7.3. Automatic transmission А4LD
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



7.2. A mechanical transmission of type МТ 75

7.2.1. A technical characteristics
THE GENERAL DATA

The transmission three-total, a classical design, has five synchronised transfers for advance (4 transfer – a straight line) and the synchronised transfer of a backing. The box is established along a car axis behind the engine. The gear change lever is established on a car floor. It is established on cars since October, 1988.

The basic distinctions in comparison with a type transmission


The maximum moment on an input
300 Nanometers
Method of consolidation of planes картера
By means of special герметизирующей pastes

Gear wheels are established on needle bearings.

The reverse gear is synchronised.

Internal directing the gear change lever has protection against casual inclusion of transfer of a backing.

Transfer numbers

CARS WITH ENGINES NRA AND N9B

Transfer
Transfer number of transfer
Transfer number of the main transfer
Full transfer number
1
3,89
3,92
15,248
2
2,08
8,153
3
1,34
5,252
4
1,00
3,920
5
0,82
3,214
Backing
3,51
13,759

CARS WITH ENGINES N8B

Transfer
Transfer number of transfer
Transfer number of the main transfer
Full transfer number
1
3,89
3,14
12,21
2
2,08
6,53
3
1,34
4,20
4
1,00
3,14
5
0,82
2,57
Backing
3,51
11,02

Greasing

Quantity of oil
1,20 дм3
Type
Oil for transmissions Ford ЕSD M2C 186 A
Periodicity of service
Level check each 20 000 km or once a year; periodic replacement of oil is not provided

The tightening moments

Carter of the block of gear wheels to картеру couplings
20 – 27 Nanometers
Carter of coupling to the block of cylinders of the engine
29 – 41 Nanometers
Fastening of the directing plug выжимного the coupling bearing
15 – 17 Nanometers
Holder of the bearing of an intermediate shaft:
  – 1 stage
15 – 20 Nanometers
  – 2 stage
To weaken on 60
Fastening of a nut of the bearing
9 – 11 Nanometers
Fastening of an axis of transfer of a backing to картеру
8 – 11 Nanometers
Bolt of a stopper of transfer of a backing to картеру transmissions
18 – 25 Nanometers
Nut of an intermediate shaft
200 Nanometers
Stopper of a stopper of the selector
20 – 27 Nanometers
Stopper of an aperture of filling and oil plum
23 – 32 Nanometers
Fastening of a lock ring of the ball bearing of a secondary shaft
20 – 27 Nanometers
The switch of lanterns of a backing
10 – 14 Nanometers