FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
- 13. A body
   13.1. Care of a body
   + 13.2. A cowl
   + 13.3. Doors
   - 13.4. External elements of a body
      13.4.1. Removal and installation of the cylinder of the lock of a mouth of a gulf of fuel
      13.4.2. Removal and installation of a cover of the hatch
      13.4.3. Removal and installation of a windscreen and motionless glasses
      13.4.4. Removal and installation of decorative overlays of a windscreen
      13.4.5. Removal and installation of decorative overlays of glass of a back door
      13.4.6. Removal and installation of emblems
      13.4.7. Adjustment of height of installation of a forward bumper
      13.4.8. Removal and installation of bumpers
      13.4.9. Removal and installation of overlays of a bumper
      13.4.10. Removal and installation of a forward spoiler
   + 13.5. Salon elements
   + 13.6. Heating and ventilation system
   + 13.7. The conditioner
+ 14. An electric equipment



13.4.9. Removal and installation of overlays of a bumper

MODELS TO THE MIDDLE OF 1990 (ALL MODELS, EXCEPT GHIA)

PERFORMANCE ORDER
1. To remove a bumper.
2. To separate an old overlay from a bumper.
3. To clean the rests of glue from a flute for an overlay in a bumper. To wash out a flute methyl spirit and to dry it.
4. A thin and uniform layer to put in a flute a glutinous ground and to allow to it to dry up. The ground is delivered together with a new overlay.
5. Slightly to warm up a new overlay. Not to turn off an overlay in rings in diameter it is less 300 mm.
6. To remove from an overlay a protective film. To insert overlay edge into a groove on one of the ends of a flute for an overlay in a bumper on depth of 10 mm. To press an overlay into a flute, moving along a bumper, and other end to insert into a groove on other end of a bumper.

The prevention

Not to cut off an overlay, as their end faces загерметизированы from moisture penetration.


7. To establish a bumper.

MODELS GHIA AND ALL MODELS FROM THE MIDDLE OF 1990

Differences at removal and installation of overlays consist in the following:

  – Except glue the overlay fastens nuts on hairpins;
  – The sticky tape for overlay gluing is delivered separately from an overlay.