FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Forward brakes
   + 11.3. Back brakes
   11.4. Adjustment of a manual brake
   11.5. Removal of air from brake system
   - 11.6. Antiblocking system
      11.6.1. Functioning check
      11.6.2. Removal and installation of hydraulic knot of management
      11.6.3. Removal and installation of a brake pedal
      11.6.4. Removal and installation of the accumulator of hydraulic knot
      11.6.5. Removal and installation of the pump and the engine of hydraulic knot
      11.6.6. Replacement of the gauge of speed of rotation of a forward wheel
      11.6.7. Replacement of the gauge of speed of rotation of a back wheel
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment



11.6.7. Replacement of the gauge of speed of rotation of a back wheel
THE GENERAL DATA

The prevention

The brake liquid is in a contour of back brakes under a high pressure. It is not necessary to press a brake pedal.


Removal

PERFORMANCE ORDER
1. To weaken nuts of fastening of a corresponding back wheel.
2. To lift the car and to remove a wheel.
3. To release the lever of a manual brake.
4. To lift back sitting and to reject a floor covering forward.
5. To take a wire from скобы and to disconnect an electric socket (it is specified by an arrow) from the gauge of speed of rotation of a wheel.
6. To disconnect a cable of a manual brake from скобы on the lever of a back suspension bracket.
7. To take a forward bolt of fastening of a brake support.
8. To turn a support upwards.
9. To unscrew a bolt of fastening of the gauge and to take it.

Installation

PERFORMANCE ORDER
1. To clear a nest of fastening of the gauge of speed of rotation of a wheel of a dirt, rust traces etc.
2. Slightly to grease a nest of fastening of the gauge with greasing for bearings.
3. To establish a new sealing ring of round section on the gauge.
4. To execute the same initial actions which are resulted at installation of the gauge of speed of rotation of a forward wheel in subsection 11.6.6, and then to execute in return sequence the actions resulted at removal of the gauge of speed of rotation of a back wheel.