FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
- 8. A kardannyj shaft and the back bridge
   8.1. A technical characteristics
   + 8.2. A kardannyj shaft
   - 8.3. The back bridge
      8.3.1. Removal and installation of the back bridge
      8.3.2. Dismantling and assemblage of the back bridge
      8.3.3. Differential dismantling
      8.3.4. Differential assemblage
      8.3.5. Adjustment of bearings of gear wheels of the main transfer
      8.3.6. Adjustment of gear wheels of the main transfer
      8.3.7. Assemblage and adjustment of the main transfer
      8.3.8. Replacement of a sealing ring of a gear wheel of the main transfer
   + 8.4. Power shafts
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


8.3.7. Assemblage and adjustment of the main transfer
THE GENERAL DATA

Measurement of a backlash of the main transfer


PERFORMANCE ORDER
1. To establish bearings on a differential box, observing a former arrangement of co-operating elements.
2. To establish on a flange of adjustment of a backlash of bearings new linings of round section, and also new sealing rings (the adaptation 15.076).
3. To oil bearings of a box of differential of the same type, as for the back bridge.
4. To establish differential, and also flanges of adjustment of a backlash of bearings and to screw up their hand that bearings became into place.
5. After performance (hand) of several tens turns by a gear wheel of the main transfer (for packing of conic bearings of a box of differential) gear wheels of the main transfer should be so are adjusted, that the backlash was not felt almost.
6. To establish the holder of the indicator of hour type on a differential box, and its measuring tip to rest at right angle against one of teeths of a conducted gear wheel of the main transfer.
7. To tighten a flange of adjustment of a backlash of the bearing of a box of differential of from outside conducted gear wheel of the main transfer and to weaken a flange of adjustment of a backlash of the bearing, located on an opposite side, so that to receive межзубьевый a backlash of the main transfer equal 0,01 mm.
8. To screw up a flange of adjustment of a backlash of the bearing from outside differential on 4–5 teeths.
9. To turn repeatedly a gear wheel of the main transfer and to measure межзубьевой a backlash in three places of a conducted gear wheel of the main transfer (approximately everyone 120 ).
10. To establish clamps (from unscrewing) flanges of adjustment of a backlash of bearings.
11. To establish a cover картера the back bridge together with a new lining, and also the tablet with the identification data.