FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   - 3.5. Diesel engines
      3.5.1. A technical characteristics
      3.5.2. The repair which is not demanding removal of the engine
      3.5.3. Check and adjustment of backlashes of valves
      + 3.5.4. Fuel system
      - 3.5.5. A head of the block of cylinders
         3.5.5.1. Removal of a head of the block of cylinders
         3.5.5.2. Installation of a head of the block of cylinders
         3.5.5.3. Check and repair of a head of the block of cylinders
      3.5.6. Removal and engine installation
      + 3.5.7. Dismantling, repair and engine assemblage
      3.5.8. turbocharger
      + 3.5.9. Greasing system
      + 3.5.10. Cooling system
      3.5.11. Typical malfunctions of the engine
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


3.5.5.2. Installation of a head of the block of cylinders
THE GENERAL DATA

Designation of a thickness of a lining of a head of the block of cylinders

Sequence of a tightening of bolts of fastening of a head of the block of cylinders


PERFORMANCE ORDER
1. Carefully to clear surfaces прилегания linings in the block of cylinders and a head, and also apertures for bolts of fastening of a head of the block of cylinders.
2. To screw up aligning adjusting pins 21.083.
3. To establish a new lining of a head of the block of cylinders of a corresponding thickness, having checked up accuracy of its packing. Cautiously to establish a head, to screw up a hand bolts of fastening and to replace two aligning pins with two bolts of fastening of a head of the block of cylinders.
4. To grease with engine oil the ends of cores of pushers and to arrange them so that they co-operated with the same pushers with which they worked before removal of a head of the block of cylinders. To establish a lining of the pipeline of giving of oil and an axis of the lever of valves. To tighten bolts and nuts of holders of an axis of the lever of valves.
5. To tighten bolts of fastening of a head of the block of cylinders, observing sequence of a tightening (fig. Sequence of a tightening of bolts of fastening of a head of the block of cylinders see), the recommended moments and a tightening method (the tab. the tightening Moments see).
6. To adjust a backlash of valves.
7. To screw up candles накаливания.
8. To establish the generator and to connect electric wires.
9. To establish atomizers and to connect their pipelines.
10. To connect hoses of system of cooling and to fill cooling system.