FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
- 10. Suspension brackets
   + 10.1. A forward suspension bracket
   - 10.2. A back suspension bracket
      10.2.1. A technical characteristics
      - 10.2.2. Service and repair
         10.2.2.1. Shock-absorber replacement
         10.2.2.2. Replacement of a spring of a suspension bracket
         10.2.2.3. Removal and installation of the lever of a suspension bracket
         10.2.2.4. Replacement металлорезиновой plugs of a beam of a back axis
         10.2.2.5. Removal and stabilizer installation
         10.2.2.6. Replacement of bearings of a nave of a wheel
         10.2.2.7. System of adjustment of a road gleam (road clearance)
         10.2.2.8. Removal and compressor installation
         10.2.2.9. Replacement of the gauge of height
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


10.2.2.3. Removal and installation of the lever of a suspension bracket
PERFORMANCE ORDER
1. To remove a protective cap of a back wheel and to weaken nuts of fastening of a wheel.
2. To lift and fix a back part of the car, to remove a corresponding back wheel.
3. To remove a back pillow of fastening of the muffler.
4. To disconnect a flexible brake hose from the brake pipeline and to muffle its corresponding stopper. To disconnect brake tubes from скоб fastenings on the lever.
5. To remove a brake drum.
6. To disconnect a cable of a drive of a lay brake from скоб fastenings on the lever. To remove a cable of a lay brake from the brake mechanism.
7. To unscrew a power shaft from a nave.
8. To remove a nave.
9. To disconnect the stabilizer of cross-section stability from a rack.
10. To establish a jack under the lever of a suspension bracket and to lift the lever so that all loading had on a suspension bracket spring.
11. To unscrew the bottom fastening (it is specified by an arrow) shock-absorber.
12. To unscrew from the corresponding party bolts of fastening of a beam of a back axis to a body after bending back of a safety lining and unscrewing of a bolt of fastening металлорезиновой plugs, and also two bolts of fastening of a support of this plug to a body.
13. Cautiously to lower the lever downwards.
14. To take a suspension bracket spring together with a rubber basic cup.
15. To remove the lever from a beam of a back axis.
16. Installation is made in sequence, return to removal.